Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Construction in Pomona, CA | Alder Contractors
CWS cabinets and countertops fail differently in Pomona than they do ten miles east, and that’s the crux of it. We install, reface, repair, and replace CWS cabinetry and quartz or granite tops across 91766, 91767, 91768, and 91797. Alder Contractors is an independent contractor and our General Contractor in Pomona is not authorized, sponsored, or warranty-backed by CWS. That independence means we tell you straight what’s fixable, what isn’t, and what it’ll cost before we touch anything. Call us at (833) 467-7020 and we’ll come look at your kitchen, cabinet run, or countertop.
Why Pomona Residents Choose Us for CWS Service
We work on CWS cabinets and tops every week, in kitchens that range from 1920s Craftsman bungalows with sloping pier-and-beam floors to clean 1990s tract boxes in 91768. That range matters because CWS hardware and boxes perform very differently in each. A Level or frameless box that drops right into a newer north Pomona kitchen isn’t the same job on a floor that’s settled an inch over ninety years.
Nelson Ibarra, our owner, grew up in the Willow Avenue corridor of Rialto and spent nearly three decades working Inland Empire homes before Alder Contractors. His dad was a drywall finisher who dragged him onto job sites as a kid, so when Nelson says a hinge screw pulled out because the box was never shimmed level, he’s not repeating a training manual. He’s seen it happen. We carry matched CWS hinges, glides, and door fronts for common RTA and assembled lines, and we step to quality aftermarket hardware when the original is undersized or discontinued. For Pomona homeowners, that means one contractor who knows both the cabinetry and the foundation it sits on – and that’s rarer than it should be.
Styles & brands we work with
Common CWS Construction Problems We Solve in Pomona
- Swollen sink bases and toe kicks in 91766 and 91767. The pre-1940 bungalows around downtown Pomona sit on raised pier-and-beam foundations with air moving underneath. A slow supply-line weep or drain leak often goes days before anyone notices water on a tile floor, and by then the particleboard box has swollen. We cut out the failed section or rebuild the run, and we always check the plumbing before setting new cabinets.
- Peeling thermofoil and laminate door edges after Pomona heat. Those 100°F-plus summers, combined with heat radiating off west-facing stucco walls, delaminate cabinet door skins at the edges. We see it constantly in north Pomona tract homes where the kitchen shares a west wall. Sometimes a door-front replacement is enough; other times the skin has failed across enough doors that refacing the run makes more sense.
- Hinge screws pulling out of particleboard stiles on sloped floors. When a CWS cabinet isn’t shimmed level on a sloping pier-and-beam floor, the doors pull unevenly and the hinge screws tear loose from the particleboard. We re-level with a ledger and shims before resetting hardware, because screwing the same hinge back into the same hole just moves the problem six months down the road.
- Quartz and granite cracking at sink cutouts and overhangs. Expansive clay under Pomona’s older neighborhoods moves seasonally, and when the cabinet base settles unevenly, a quartz top has nowhere to flex. The crack forms at the weakest point: the sink cutout or an unsupported overhang. Replacing the top without fixing the substrate just means you’ll buy another top in two years.
- Full kitchen remodels on raised foundations where nothing is square. Homeowners in 91766 and 91767 often plan a cabinet and countertop refresh, then discover the floor has sloped for decades. We level the run, set new CWS boxes on shims, and reset tops so doors close flush and drawers don’t self-open.
CWS Service in Pomona: What Local Conditions Mean for Your Equipment
Pomona’s 91766 and 91767 core is dominated by pre-1940 bungalows on raised pier-and-beam foundations over expansive clay, and that one fact ripples through every CWS kitchen we touch there. A tract-heavy Inland Empire city to the east sits on slab foundations that barely move, so a CWS service in Claremont might involve a cabinet run that drops in, gets screwed to level boxes, and stays put. In Pomona’s historic core, the floor has often sloped for decades, and the kitchen cabinets have sloped with it. Door reveals go uneven. Drawer glides bind. Quartz tops pick up stress at the sink cutout. We don’t just swap out the failed part; we re-level the run so the failure doesn’t just migrate to the next weak point. On a 1920s bungalow near downtown Pomona in 91766, our crew tore out a water-swollen sink base and found the pier-and-beam floor had dropped nearly an inch across the run. That drop had pulled the CWS hinge screws loose and cracked the quartz at the sink cutout. We sistered and re-leveled the framing, set new CWS shaker cabinets on shims with a continuous ledger, and reset a fresh quartz top with a reinforced cutout. The doors close flush and the counter sits dead level. That’s the kind of fix you can’t spec from a showroom drawing.
CWS Models & Products We Service in Pomona
We install, reface, and repair the CWS lines Pomona homeowners actually buy: Ready-to-Assemble shaker and flat-panel cabinets from major home centers, pre-assembled white and woodgrain thermofoil boxes, frameless lines, and CWS quartz and granite slab and prefab vanity tops. We match OEM CWS hinges, glides, and replacement door fronts when the box is structurally sound, and we step to quality aftermarket hardware when the original is discontinued or undersized. For Pomona turnaround, we keep common door fronts and hinge kits in stock, and we source mats and slabs directly from our supplier network for the countertop side. When a cabinet box has swelled or delaminated past the frame, we’ll tell you honestly that rebuilding the run beats patching it. Do it right the first time – the callback always costs more than the extra hour up front.
See the difference
Before
After
Before
After
Before
AfterCWS Service Pricing in Pomona
| Service | Pomona Market Range |
|---|---|
| Cabinet Installation | $4,000 – $13,000 |
| Countertop Installation | $2,000 – $6,500 |
| Kitchen Remodel | $14,000 – $45,000 |
| Small Kitchen Remodel | $9,000 – $20,000 |
| Kitchen Island Installation | $3,000 – $10,000 |
Your price lands inside those ranges based on how many linear feet of cabinet run, whether we’re doing a single top or a full island, and how much floor leveling or substrate repair the Pomona house needs beneath it. An older 91767 bungalow with a settled pier-and-beam kitchen will run higher than a clean 91768 tract install because the prep work is real. We write a line-item quote, not a guess, and the estimate is free. Call (833) 467-7020 and we’ll put numbers on paper.
Serving Pomona, CA — Our Local Coverage Area
We’re based in the Pomona area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – CWS Construction in Pomona
In most cases, peeling thermofoil or laminate edges can be fixed by replacing the affected door fronts or recladding the run, as long as the box itself is still square and dry. The decision depends on how many doors have failed and whether the underlying MDF has absorbed moisture. Call (833) 467-7020 and we’ll tell you which side of that line your kitchen falls on.
Almost always, it’s movement. In 91767’s older pier-and-beam homes, the floor settles seasonally over expansive clay, and the cabinet run beneath the quartz moves with it. The sink cutout is the structural weak point where that movement concentrates, and quartz doesn’t flex. The fix requires leveling the cabinet run, not just swapping the top. Call (833) 467-7020 for an assessment.
Yes. We shim and ledger every CWS run on a raised foundation, and we’ve leveled cabinets on floors that were out by more than an inch across ten feet. The key is doing the leveling work before the boxes go in, not debating it after the doors bind. We measure, we level, we set – same sequence on every job.
Yes, and that’s the only way we do it. When one contractor sets the boxes and cuts the tops, the overhangs and sink cutout get matched to the actual installed dimensions rather than a drawing. We’ve seen mismatched contractor jobs where the top was templated before the run was leveled, and the result was a seam where no seam should exist. Single-contract coordination is the fix.
For a 91768 tract kitchen, Los Serranos CWS service often involves RTA shaker lines and assembled white thermofoil boxes that are a solid value, and we install them regularly in those homes. The slab foundation and square framing mean the boxes drop in clean, and the budget can go toward countertops and hardware instead of substrate repair. Prices for a small kitchen remodel in Pomona typically run $9,000 to $20,000. Call (833) 467-7020 for an exact number.
Service Areas Near Pomona
Our crews run CWS jobs throughout eastern LA County and into the San Bernardino Valley. If you’re just outside Pomona, we also serve CWS service in La Verne, CWS service in Hesperia, plus Bloomington, Muscoy, and Fontana. For a broader look at the region, see our Pomona service area page. And for the full picture on what we do with CWS lines, start with our CWS sales & service overview.
Book Your CWS Service in Pomona Today
We’ll come look at your CWS cabinets, doors, hinges, or countertops and give you a straight answer on what needs to happen and what it costs. Call (833) 467-7020 and ask for a free estimate. One contractor, every phase.
Written by Nelson Ibarra, Owner at Alder Contractors, serving Pomona and the Inland Empire for nearly three decades.